#LapWorks Armbot Bed and Desk Mount for Posing Your iPad or Tablets For Easy and Relaxed Viewing
The Armbot Bed & Desk Mount for iPads and Tablets is the first mounting bracket that gives you the option of attaching it to your desk or table or wall mounting. And now we've added the vehicle mounting bracket. Besides these four mounting systems, the Armbot is also a modular design where you can shorten it to one arm section, two arm sections or use all three arm sections for the most flexible posing options. The Armbot is made of three separate lengths of 5/8" diameter Aluminum tubing that combine to create an amazing number of posing and elevating viewing positions. Each tube length is 11.81" long and they are joined by durable Nylon tightening hinges. Each arm section can be detached and reattached easily. At full extension, the Armbot reaches out over 37.4" from it's mounting bracket. The desk mounting C-clamp bracket is made of Zinc alloy and can be attached to the edge of any desk, table top, headboard, nightstand, kitchen counter, end table or coffee table. The C-clamp can open as wide as 2-3/8". The wall mounting bracket is also made of Zinc alloy and needs to be attached to a wall with 4 screws that are included in every box. Or attach the wall bracket to any wall near your bed or favorite lounging area for anytime viewing in total comfort. Or attach it under a kitchen cabinet so the iPad is always available when needed. The vehicle mount is also made of Zinc alloy and simply slides in under you passenger seat's sliding rail after you have loosened it to allow the bracket to slide into place. Then simply re-tighten. The Armbot comes with a 4-prong holding bracket that can open wide enough to grip your iPad or tablet in landscape mode. The four grips have soft rubber pads that protect your device and the grips are expandable so they can accommodate any iPad or tablet with the case attached. |
No comments:
Post a Comment